Fujitsu Stylistic Q702 Manuel d'instructions télécharger pdf (Page 33)

- Active Digitizer/Touchscreen

Replacing the Pen Tip

With use, the pen tip may become worn or may pick up foreign

particles that can scratch the screen. A damaged or worn tip may not

move freely, causing unpredictable results when using the pen. If a

problem like this should occur, you should replace the pen tip.

1 Pull the tip from the barrel.

2 Using one of the new tips that were supplied with your pen,

insert the pointed end of the tip into the barrel and push it in

firmly until it is in place

Figure 14. Replacing the Pen Tip

Installing a Pen Tether

To prevent dropping or losing your pen, you should attach

it to your system using the pen tether that is included with

the system.

To attach the pen tether to your Hybrid Tablet, perform the

following steps:

1 Attach the end of the pen tether with the smaller loop

to your pen. To do so, push the end of the tether under

the slot on the top of the pen, then thread the opposite

end of the tether through the loop.

2 Attach the end of the pen tether with the larger loop to

the attachment point on the right side of your tablet.

To do so, insert the end of the pen tether through the

attachment point, then feed the pen through the large

loop in the tether.

Figure 15. Installing a Pen Tether

Pen Tip

Pen Barrel

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 237 238

Pas de commentaire

Fujitsu Stylistic Q702 Manuel d'instructions Page 33