Fujitsu P3NK-4452-01ENZD Manuel d'utilisateur télécharger pdf (Page 51)

XG Series User's Guide Chapter 2 Using the CLI

Using the CLI

Replacing command strings

By entering a single-replacement specifier (:s) or all-replacement specifier (:gs) following a history specifier and

replacement specifier, you can replace the target string and re-execute the command string.

A single-replacement specifier replaces the first matching string only, while an all-replacement specifier replaces all

matching strings.

The replacement target string and replacement string are specified as with string replacement for the preceding command;

however, arbitrary characters (@, #, %, &, ~, =, _, etc.) may be used as delimiters. You can successively enter a single-

replacement specifier, all-replacement specifier, and display specifier.

The table below lists specifiers and operations. This example uses "/" as a delimiter.

(A: replacement target string, B: replacement string, C: additional string)

A command execution example is shown below.

z Command

Command Operation

:s/A/B/ Replace only the first instance of A with B and execute the command string.

:ps/A/B/ Replace only the first instance of A with B and display the command string.

:s/A/B/C Replace only the first instance of A with B, add C to the command string, and execute it.

:ps/A/B/C Replace only the first instance of A with B, add C to the command string, and display it.

:gs/A/B/ Replace all instances of A with B and execute the command string.

:pgs/A/B/ Replace all instances of A with B and display the command string.

:gs/A/B/C Replace all instances of A with B, add C to the command string, and execute it.

:pgs/A/B/C Replace all instances of A with B, add C to the command string, and display it.

:s/A// Delete only the first instance of A and execute the command string.

:ps/A// Delete only the first instance of A and display the command string.

:s/A//C Delete only the first instance of A, add C to the command string, and execute it.

:ps/A//C Delete only the first instance of A, add C to the command string, and display it.

:gs/A// Delete all instances of A and execute the command string.

:pgs/A// Delete all instances of A and display the command string.

:gs/A//C Delete all instances of A, add C to the command string, and execute it.

:pgs/A//C Delete all instances of A, add C to the command string, and display it.

:s/A1/B1/:gs/A2/B2/:p Replace only the first instance of A1 with B1, replace all instances of A2 with B2, and display the

command string.

# lan 0 ip address 192.168.0.1/24 3

# !!:gs/0/1/:p (Replace all instances of 0 with 1 and display the command string.)

lan 1 ip address 192.168.1.1/24 3

# !! (Re-execute the last command to run.)

lan 1 ip address 192.168.1.1/24 3

Note

When entering a command with the command history function, you can omit the last delimiter (/, ^, etc.) at the end of the

command line. However, when the last delimiter is omitted, you cannot specify a display specifier (:p), additional history

specifier, or additional string.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 613 614

Pas de commentaire

Fujitsu P3NK-4452-01ENZD Manuel d'utilisateur Page 51