Fujitsu ScanSnap S500M Manuel d'utilisateur télécharger pdf (Page 17)

ScanSnap S500M for Macintosh Getting Started | 15

TTENTION

Make sure that the Pad ASSY is firmly

secured. If it is not secured, documents will

jam or other feeding errors may occur.

5. Close the ADF

Ö Gently push the ADF until you hear it click when

returning it to its original position.

6. Turn on the scanner.

Ö The ScanSnap Manager icon changes from the

inactive state

to the active state .

7. Click and hold down the mouse button on the

"ScanSnap Manager" icon

in the Dock menu, and

select [Check consumable supplies] from the pop-up

menu.

8. In the “Check consumable status” window, click the

[Reset] button of the consumable you replaced.

Ö A confirmation pop-up screen appears.

Ö If you click the [Yes] button, the counter is reset to

“0.”

6.3. Replacing the Pick Roller

Replace the Pick roller following the procedures below.

1. Remove the document on the Paper chute if any.

2. Pull the Cover open lever and open the ADF.

3. Adjust the Side Guide to the “A5” size.

4. Pinch the handle on the Sheet guide to remove it.

5. Rotate the Pick roller bushing (Left) in the direction of

the arrow.

ADF

Paper chute

Cover open lever

Pick roller shaft

Pick roller bushing

Pick roller

Handle

Sheet guide

Claw

ADF

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Fujitsu ScanSnap S500M Manuel d'utilisateur Page 17