Fujitsu M3000 Manuel d'utilisateur télécharger pdf (Page 39)

Chapter 3 Installing the Server 3-5

Note – It is possible to connect it to a LAN port via telnet or SSH access. The LAN

port has a Class B private address value, but it will not send out a packet by itself

until configured.

Note – The modular connector (RCI connector) is not for use with a TNV circuit

connection. See Item 1 in FIGURE 3-2.

1. Confirm that the following settings have been made for software on the

administration console.

2. Prepare the serial cable.

The serial cable is supplied with the server.

3. Connect the serial port on the rear panel to the administration console.

FIGURE 3-2 shows the locations of the external interface port such as serial port

and LAN ports on the rear panel.

TABLE 3-1 Terminal Software Setting Values

Setting item Value

Baud rate 9600

Data length 8 bits

Parity None

STOP bit 1 bit

Flow control None

Delay Other than 0

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 75 76

Pas de commentaire

Fujitsu M3000 Manuel d'utilisateur Page 39