Fujitsu B3020D Manuel d'utilisateur Page 68
- Page / 115
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
61
Troubleshooting
POWER ON SELF TEST MESSAGES
The following is an alphabetic list of error-and-status
messages that Phoenix BIOS and/or your operating
system can generate and an explanation of each message.
Error messages are marked with an *. If an error
message is displayed that is not in this list, write it down
and check your operating system documentation both
on screen and in the manual. If you can find no
reference to the message and its meaning is not clear,
contact your support representative for assistance.
nnnn Cache SRAM Passed
Where nnnn is the amount of system cache in kilobytes
successfully tested by the Power On Self Test. (This can
only appear if you have an SRAM PC Card installed.)
*Diskette drive A error or Diskette drive B error
Drive A: or B: is present but fails the BIOS Power On Self
Test diskette tests. Check to see that the drive is defined
with the proper diskette type in the Setup Utility, See
“BIOS Setup Utility” on page 29. and that the diskette
drive is installed correctly. If the disk drive is properly
defined and installed, avoid using it and contact your
support representative.
*Extended RAM Failed at offset: nnnn
Extended memory not working or not configured prop-
erly. If you have an installed memory upgrade module,
verify that the module is properly installed. If it is prop-
erly installed, you may want to check your Windows
Setup to be sure it is not using unavailable memory
until you can contact your support representative.
nnnn Extended RAM Passed
Where nnnn is the amount of memory in kilobytes
successfully tested.
*Failing Bits: nnnn The hex number nnnn
This is a map of the bits at the memory address (in
System, Extended, or Shadow memory) which failed the
memory test. Each 1 (one) in the map indicates a failed
bit. This is a serious fault that may cause you to lose data
if you continue. Contact your support representative.
*Fixed Disk x Failure or Fixed Disk Controller
Failure (where x = 1-4)
The fixed disk is not working or not configured prop-
erly. This may mean that the hard drive type identified
in your setup utility does not agree with the type
detected by the Power On Self Test. Run the setup utility
to check for the hard drive type settings and correct
them if necessary. If the settings are OK and the message
appears when you restart the system, there may be a
serious fault which might cause you to lose data if you
continue. Contact your support representative.
*Incorrect Drive A type – run SETUP
Type of floppy drive A: not correctly identified in Setup.
This means that the floppy disk drive type identified in
your setup utility does not agree with the type detected
by the Power On Self Test. Run the setup utility to
correct the inconsistency.
*Incorrect Drive B type – run SETUP
Type of floppy drive B: not correctly identified in Setup.
This means that the floppy disk drive type identified in
your setup utility does not agree with the type detected
by the Power On Self Test. Run the setup utility to
correct the inconsistency.
*Invalid NVRAM media type
Problem with NVRAM access. In the unlikely case that
you see this message you may have some display prob-
lems. You can continue operating but should contact
your support representative for more information.
*Keyboard controller error
The keyboard controller test failed. You may have to
replace your keyboard or keyboard controller but may
be able to use an external keyboard until then. Contact
your support representative.
*Keyboard error
Keyboard not working. You may have to replace your
keyboard or keyboard controller but may be able to
use an external keyboard until then. Contact your
support representative.
*Keyboard error nn
BIOS discovered a stuck key and displays the scan code
for the stuck key. You may have to replace your keyboard
but may be able to use an external keyboard until then.
Contact your support representative.
*Monitor type does not match CMOS – Run SETUP
Monitor type not correctly identified in Setup. This
error probably means your BIOS is corrupted, run the
setup utility and set all settings to the default conditions.
If you still get this error, contact your support represen-
tative.
*Operating system not found
Operating system cannot be located on either drive A: or
drive C: Enter the setup utility and see if both the fixed
disk, and drive A: are properly identified and that the
boot sequence is set correctly. Unless you have changed
your installation greatly, the operating system should be
on drive C:. If the setup utility is correctly set, your hard
drive may be corrupted and your system may have to be
re-installed from your back up media.
B Series.book Page 61 Friday, April 23, 2004 11:41 AM
- Fujitsu LifeBook 1
- B Series 1
- Copyright 2
- Table of Contents 4
- USER-INSTALLABLE FEATURES 5
- TROUBLESHOOTING 5
- CARING FOR YOUR 5
- LIFEBOOK NOTEBOOK 5
- SYSTEM SPECIFICATIONS 6
- GLOSSARY 6
- APPENDIX: 6
- WIRELESS LAN USER’S GUIDE 6
- ABOUT THIS GUIDE 10
- FUJITSU CONTACT INFORMATION 10
- WARRANTY 10
- Getting to Know 12
- Your LifeBook 12
- Overview 14
- Locating the Controls 15
- LEFT-SIDE PANEL COMPONENTS 16
- RIGHT-SIDE PANEL COMPONENTS 17
- BOTTOM COMPONENTS 18
- Anti-theft lock slot 19
- Status Indicator Panel 20
- Keyboard 22
- Touchpad Pointing Device 24
- TOUCHPAD CONTROL ADJUSTMENT 25
- TOUCH SCREEN 25
- Getting to Know Your LifeBook 26
- Volume Control 27
- (1) Application A Button 28
- (3) Internet Button 28
- (2) Application B Button 28
- (4) E-Mail Button 28
- Enter Button 28
- APPLICATION PANEL 29
- PRECAUTIONS 29
- UNINSTALLING THE SECURITY 29
- PANEL APPLICATION 29
- LAUNCHING APPLICATIONS WITH 30
- Getting Started 32
- Power Sources 34
- Display Panel 35
- Starting Your 36
- LifeBook Notebook 36
- BOOTING THE SYSTEM 37
- Registration 38
- Power Management 39
- HIBERNATE MODE 40
- DISPLAY TIMEOUT 40
- HARD DISK TIMEOUT 40
- WINDOWS POWER MANAGEMENT 40
- RESTARTING THE SYSTEM 40
- POWER OFF 41
- User-Installable 42
- Features 42
- Lithium ion Battery 44
- REPLACING THE BATTERY 45
- External Floppy 46
- Disk Drive* 46
- Write Protected 47
- Write Enabled 47
- PC Cards 48
- Compact Flash Cards 49
- REMOVING COMPACT FLASH CARDS 50
- Memory Upgrade Module 51
- OF NEW MEMORY CAPACITY 52
- Port Replicator 53
- FRONT PANEL COMPONENTS 54
- ATTACHING THE PORT REPLICATOR 54
- DETACHING THE PORT REPLICATOR 54
- Device Ports 55
- DOCKING PORT 56
- MICROPHONE JACK 56
- HEADPHONE JACK 56
- EXTERNAL MONITOR PORT 56
- Diskette Controller: 61
- Disabled 61
- POWER ON SELF TEST MESSAGES 68
- MODEM RESULT CODES 69
- Restoring Your 70
- Pre-installed Software 70
- AUTOMATICALLY DOWNLOADING 71
- DRIVER UPDATES 71
- Care and Maintenance 72
- BATTERIES 75
- FLOPPY DISKS AND DRIVES 75
- PC CARDS 76
- BatteryAid 82
- Glossary 84
- Regulatory Information 91
- ACCORDING TO LOCAL, STATE, OR 93
- FEDERAL LAWS 93
- Appendix 94
- FCC REGULATORY INFORMATION 96
- Before Using the Wireless LAN 97
- DEACTIVATING THE WLAN DEVICE 98
- Wireless LAN 99
- On/Off Switch 99
- FLOW OF OPERATIONS 100
- CONFIGURATION USING WIRELESS 100
- ZERO CONFIGURATION TOOL 100
- INTEL PROSET SOFTWARE 101
- CONFIGURATION USING 101
- CONFIGURATION USING ATHEROS 102
- CLIENT UTILITY SOFTWARE 102
- CONNECTION TO THE NETWORK 104
- WIreless LAN User’s Guide 106
- Troubleshooting 107
- Wireless LAN Glossary 108
- IP address information 110
- Specifications 111
- LifeBook B Series 113
Produits connexes et manuels pour Carnets de notes Fujitsu B3020D
(136 pages)
(418 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.308 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels