Fujitsu Stylistic Q704 Manuel d'instructions télécharger pdf (Page 93)

Appendix

Image Backup and Recovery Procedures

Thank you for purchasing a Fujitsu computer. Fujitsu is committed to bringing you

the best computing experience with your new system.

It is very important that you create DVD copies of your Recovery Image and Bootable Disk

before beginning to use your system. To do s o, follow the instructions in the “Creating a

Backup of Bootable Disk and Recovery Image” section of this documen t.

It is also important that you create a copy of the software that is essential for your system to access the

internet (hereafter called “essential access software”) to externa l writable media or an external drive.

To do so, follow the instructions in the “Creating a Backup of the System-Speciﬁc Software Drivers ”.

Creating a Backup of Bo otable Disk and Recovery I mage

When you purchased your new syste m, a copy of the recovery image was loaded into a

hidden partition on your hard disk drive. Having a copy of the r ecove ry image available to

you means that in the event of system failure, you will b e able to restore it and re-install

the essential access software using Fujitsu Software A uto Installer.

To make a copy of the re covery image to DVD disks, you will need three or four blank

disks to create the copy. After creating the copy, be sure to label the disks and keep

them in a safe place to ensure they do not get damag ed.

Note: If your system does not have an internal writable DVD drive, connect y our

system to an external drive* before beginning the following steps.

1. Launch Syste

m Restore and Recovery from the desktop icon. It w ill allow you to create

the Bootabl

e Disk and th e Recovery Image Disk Set.

2. On “Step 1: Select the Bootable Disk from the list”:

a. Select a

media type.

b. Notice the number of disks that are need ed for the set.

c. Click N

ext to proceed.

3. On “Step 2: Conﬁrm your Recovery Disk”, click Next.

4. On “Step

3:” follow the on-screen instructions to make the disk or disk set, then click

Start.I

t takes approximately 20 minutes to make one disk.

5. On “Step 4”, when the disk creation is completed, a message appears.

Click Finish to exit the program.

6. Repea

t Step 1: Select Recovery D isk from the list and repeat the above

steps

2(a), 2(b), 2(c), 3, 4 and 5.

* DEPENDING UPON YOUR OPTICAL DRIVE AND MEDIA FORMAT USED, SOME MEDIA

TYPES MAY BE INCOMPATIBLE FOR CREATING IMAGE BACKUPS.

Fujitsu 91

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Fujitsu Stylistic Q704 Manuel d'instructions Page 93

Commentaires sur ces manuels

Produits connexes et manuels pour Carnets de notes Fujitsu Stylistic Q704