Fujitsu T1000 Manuel d'utilisateur télécharger pdf (Page 35)

Chapter 1 Preparing for Installation 9

■ Ethernet ports. The server Ethernet interfaces operate at 10 Mbps, 100 Mbps, and

1000 Mbps. The transfer rates for the Ethernet ports are given in

TABLE 1-1.

■ TTYA serial port. Use the DB-9 connector with a null modem cable for serial

devices. This port appears as ttya in Solaris OS and OpenBoot PROM™

messages. This port is not connected to the SC serial management port.

■ AC power cables. As soon as the AC power cables are connected to the power

source, the server goes into standby mode and the ALOM CMT system controller

initializes.

Tip – The serial terminal or a terminal emulator should be connected before you

connect the power cables. As soon as AC power is connected to the system, the

system controller immediately powers on and runs diagnostics. Diagnostic test

failures will be printed on the serial terminal. For more information, refer to the

Advanced Lights out Management (ALOM) CMT v1.x Guide.

Safety Precautions

Caution – Deploy the antitilt feature for your equipment rack before beginning the

installation.

TABLE 1-1 Ethernet Connection Transfer Rates

Connection Type IEEE Terminology Transfer Rate

Ethernet 10BASE-T 10 Mbit/sec

Fast Ethernet 100BASE-TX 100 Mbits/sec

Gigabit Ethernet 1000BASE-T 1000 Mbit/sec

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 83 84

Pas de commentaire

Fujitsu T1000 Manuel d'utilisateur Page 35