Fujitsu T1000 Manuel d'utilisateur télécharger pdf (Page 57)

Chapter 3 Powering On the System 31

Note – If you are unable to use DHCP and SSH on your network, you must connect

to the ALOM CMT system controller using the serial management port to

reconfigure the network management port. See “To Configure the System Controller

Network Management Port” on page 31.

1. Open a Telnet or SSH session and connect to the system controller by specifying

its network address.

The following example shows a Telnet session.

2. Login as admin using the password you previously set.

▼ To Configure the System Controller Network

Management Port

Note – If your network allows the use of DHCP and SSH, this configuration is

performed automatically at the first time you boot the system.

Use this procedure only if:

■ If you are unable to use DHCP and SSH on your network.

■ If you need to modify the SC network management port settings.

In this procedure you connect to the ALOM CMT system controller using the serial

management port to manually reconfigure the network management port.

Note – For more information on configuring ALOM CMT, refer to the Advanced

Lights Out Management (ALOM) CMT Guide.

% telnet xxx.xxx.xx.xx

Trying xxx.xxx.xx.xx...

Connected to xxx.xxx.xx.xx.

Escape character is '^]'.

Advanced Lights Out Manager 1.x

Please login:

Please login: admin

Please Enter password: password

sc>

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 83 84

Pas de commentaire

Fujitsu T1000 Manuel d'utilisateur Page 57