Fujitsu Stylistic Q702 Manuel d'instructions télécharger pdf (Page 61)

- Troubleshooting

Power On Self Test Messages

The following is a list of error-and-status messages that the Phoenix BIOS and/or your operating system can generate

and an explanation of each message. Error messages are marked with an *. If an error message is displayed that is

not in this list, write it down and check the operating system documentation on screen and in the manual. If you can

find no reference to the message, contact a support representative.

*Invalid NVRAM Data

Problem with NVRAM access. In the unlikely case that you see this message you may have a display problem. You can

continue operating but should contact your support representative for more information.

*Operating system not found

Operating system cannot be located on either drive A: or drive C: Enter the setup utility and see if both the fixed disk,

and drive A: are properly identified and that the boot sequence is set correctly. Unless you have changed your

installation greatly, the operating system should be on drive C:. If the setup utility is correctly set, your hard drive may

be corrupted.

*Real time clock error - Check date and time settings

Real-time clock fails BIOS test. May require board repair. Contact your support representative.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 237 238

Pas de commentaire

Fujitsu Stylistic Q702 Manuel d'instructions Page 61