Fujitsu Image Scanner fi-5950 Manuel d'utilisateur

P3PC-3062-01EN

1Chapter1 PREPARING THE SCANNER1.1 Checking the Contents of the Scanner PackageWhen you unpack the scanner package, make sure that the package contain

2 Removable Parts 1.3 Operator PanelThe operator panel is located on the right side of the scanner. The panel consists of a Function Number Dis-play,

3 Indications on the Function Number DisplayThe following shows the indications on the Function Number Display.Use this button to start linked applic

4Chapter2 INSTALLATION OF THE SCANNER2.1 Installing the Scanner1. Place the scanner at its installation site.For details on the scanner's dimensi

5 Connecting the SCSI interfaceWhen using the scanner with a SCSI interface, the fol-lowing SCSI cable and SCSI card must be purchased.• SCSI cableUs

63. When using the SCSI cable, set the SCSI ID using the SCSI ID switch on the back of the scanner. (Refer to step 3 in "Connecting the SCSI int

7 System RequirementsThe system requirements for fi-5950 are as follows.*1: Not supported by Kofax VRS.*2: QuickScan Pro does not support the Windows

84. Install the software, following the onscreen instructions.INSTALL (Custom)1. Perform Steps 1 and 2 in "INSTALL (Recom-mended)" (page. 7)

92.4 Checking Scanner Driver OperationThis section explains how to check the operation of the installed scanner driver by using ScandAll PRO.Make sure

1010. Click [Scanner Settings].⇒ A setup dialog box appears for you to configure scanner driver settings.11. Configure scanner settings such as the r

AP-1Appendix 1 TROUBLESHOOTING Troubleshooting checklistSymptom Check this item RemedyScanner does not turn on. Have you pushed the power button on t

AP-2Paper is not fed (pick error occurs frequently, or docu-ment stops midway).Do the documents satisfy the "Docu-ment Quality" and the &quo

AP-3 Temporary errorThe following shows the procedure for releasing of each of the temporary errors.• "J0" or "U1" error1. Remove

AP-4Appendix 2 DAILY CARE Cleaning Materials*1: For details about the cleaning materials, contact the FUJITSU scanner dealer where you purchased the

AP-5Appendix 3 REPLACING CONSUMABLES Consumables and Replacement CycleThe followings are the specifications of consumables and their recommended repl

AP-6 Pick roller Separator roller Brake rollerPick rollerSeparatorrollerPadCoverBrake rollerCover

z Copying of the contents of this manual in whole or in part and copying of the scanner application is prohibited under the copyright law.z The conten

iCONTENTSINTRODUCTION ... ii Regulatory Information ...

iiINTRODUCTIONThank you for purchasing the fi-5950 Duplex Color Scanner. This document describes how to use fi-5950 and basic operation methods. Befor

iii LiabilityREAD ALL OF THIS MANUAL CAREFULLY BEFORE USING THIS PRODUCT. IF THIS PRODUCT IS NOT USED CORRECTLY, UNEXPECTED INJURY MAY BE CAUSED TO U

iv*1:Where there is no distinction between the different versions of the above operating system, the general term "Windows" is used.*2:All t

vScreen Examples In This ManualThe screen examples in this manual are subject to change without notice in the interest of product improvement. If the

vi Do not install the scanner in the following locations which are subject to high temperature, humidity, less ventilation, or dust.

vii When installing the scanner on a table, make sure that the table is flat and level. Place the scanner so that none of its parts extend beyond the