Fujitsu FI-5530C2 Manuel d'utilisateur télécharger pdf (Page 23)

fi-5530C Image Scanner Getting Started AP-2

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

Do the documents satisfy the "Docu-

ment Quality" and the "Multi feed

Detection Conditions" in the chapter 6

of "fi-5530C2 Operator’s Guide"?

Use the documents that satisfy the "Document

Quality" and the "Multi feed Detection Condi-

tions" in the chapter 6 of "fi-5530C2 Operator’s

Guide."

Is the Pick roller dirty? Clean the Pick roller. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Is the Pick roller worn out? Clean the Pick roller. For details, refer to section

4.3 "Replacing the Pick Roller" of "fi-5530C2

Operator's Guide."

Is there any debris on the document feed

path?

Remove any debris from the document feed path.

The generated images are

elongated.

Are the Feed rollers dirty? Clean the Feed rollers. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Have you adjusted the scan magnifica-

tion?

Select "Scanners and Cameras" in the control

panel, then click the [Device Set] tab to adjust

magnification.

There is a shadow on the

leading edge of the gener-

ated image?

Are the Feed rollers dirty? Clean the Feed rollers. For details, refer to section

3.2 "Cleaning the ADF"of "fi-5530C2 Operator's

Guide."

Have you adjusted the offset (the scan-

ning starting position)?

Adjust the [Sub-scan Setting] on [Scanners and

Cameras] in the control panel.

Symptom Check this item Remedy

1 2 ... 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Fujitsu FI-5530C2 Manuel d'utilisateur Page 23