Fujitsu SPARC M3000 Manuel d'utilisateur télécharger pdf (Page 28)

2-2 C120-E360-06EN

CHAPTER 2 Setup of the RCI for Operation

2.2 RCI Setup for Initial Installation

This section explains the procedure for initial RCI setup, which assumes RCI settings

have not been configured.

Note: Perform this work when this system is not using any RCI I/O unit.

2.2.1 RCI setup flow

RCI setup for initial installation contains the following steps:

1 Confirming RCI initialization

2 Connecting RCI cables

3 Making an RCI address setting

4 Making an RCI construction setting

2.2.2 Confirming RCI initialization

Before connecting an RCI cable to an RCI host, confirm that RCI settings have been

initialized.

• To confirm RCI initialization:

1 Execute the setrci (8) command to display the RCI status.

Confirm that "address" is 000f7fff (initial address value).

If RCI settings have not been initialized, perform the next step.

2 Execute the setrci (8) command to initialize RCI settings.

XSCF> setrci -c stat

HOST

address 000f7fff

Inactive

The command completed successfully.

XSCF> setrci -c init

The command completed successfully.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Pas de commentaire

Fujitsu SPARC M3000 Manuel d'utilisateur Page 28