Fujitsu SPARC M3000 Manuel d'utilisateur télécharger pdf (Page 35)

C120-E360-06EN 2-9

2.5 RCI Setup for Replacement of an RCI I/O Unit

2.5.1 RCI setup flow

RCI setup for replacement of an RCI I/O unit contains the following steps:

1 Confirming an RCI address

2 Replacing an RCI I/O Unit

3 Making an RCI replacement setting

Note: Perform this RCI setup work for each RCI I/O unit to be replaced.

2.5.2 Confirming an RCI address

Confirm the RCI address or location of the RCI I/O unit to be replaced.

• To confirm an RCI address:

1 Push the service pin of the RCI I/O unit to be replaced.

2 Execute the setrci (8) command to display the address of the RCI I/O unit

whose service pin is pushed.

If the RCI I/O unit to be replaced has failed and cannot make a transmission, its RCI

address cannot be confirmed by the above operation. Perform the following operation

to confirm the RCI address.

XSCF> setrci -c idpin

RCI:XXXX VER:XX DATE:XXXX XX/XX XX:XX;XX

The command completed successfully.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Pas de commentaire

Fujitsu SPARC M3000 Manuel d'utilisateur Page 35