Fujitsu PRIMERGY B120 Manuel d'utilisateur télécharger pdf (Page 47)

A26361-K646-Z102-1-7619 39

7 Troubleshooting and tips

Take note of the safety notes in the manual "Safety and Ergonomics" and in the chapter

"Installation", when you connect or disconnect cables.

If a fault occurs, try to correct it according to the following procedures. These are described:

• in this chapter

• in the documentation of the connected devices

• in the help systems of the software used.

If you fail to correct the problem, proceed as follows:

Ê Note the steps carried out and the system status when the error occurred. Also make a note of

any error messages displayed.

Ê Switch the server off.

Ê Contact your customer service center.

7.1 Operation indicator remains dark

Power cord incorrectly connected

Ê Make sure that the power cable is correctly connected to the server and to the grounded power

outlet.

Power supply overloaded

Ê Pull the power plug of the server out of the power outlet.

Ê Wait a few seconds and plug the power plug into the power outlet again.

Ê Switch your server on.

7.2 The server switches itself off

Server management has detected an error

Ê In the ServerView program check the error list or check the Error Log file using the SCU utility;

and attempt to eliminate the error.

7.3 The screen stays blank

Monitor is switched off

Ê Switch your monitor on.

Screen has been blanked

Ê Press any key on the keyboard.

Ê Deactivate screen blanking (screen saver). Enter the appropriate password.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Pas de commentaire

Fujitsu PRIMERGY B120 Manuel d'utilisateur Page 47