Fujitsu Sparc Enterprise Server T5440 Manuel d'utilisateur télécharger pdf (Page 46)

30 SPARC Enterprise T5440 Server Administration Guide • July 2009

2. At the ILOM -> prompt, type:

The system is set to run full POST diagnostics on system reset.

3. To return to your normal diagnostic settings after running POST, type:

Related Information

■ “Clearing Faults” on page 33

■ “Bypassing Minor Faults” on page 31

■ “Managing Devices” on page 34

■ “Locate the System” on page 30

▼ Locate the System

1. Log in to ILOM.

See “Log In to ILOM” on page 28.

2. To easily find your system in a data center or server room, use the Locator LED

as described below.

■ To turn on the Locator LED, from the ILOM -> prompt, type:

■ To turn off the Locator LED, from the ILOM -> prompt, type:

■ To display the state of the locator LED, from the ILOM -> prompt, type:

For more information on LEDs, see your server’s service manual.

Related Information

■ “Configure a Device Manually” on page 35

■ “Clear Component Fault Messages” on page 34

-> set /SYS keyswitch_state=diag

-> set /SYS keyswitch_state=normal

-> set /SYS/LOCATE value=Fast_Blink

-> set /SYS/LOCATE value=off

-> show /SYS/LOCATE

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 71 72

Pas de commentaire

Fujitsu Sparc Enterprise Server T5440 Manuel d'utilisateur Page 46