Fujitsu S300M Manuel d'utilisateur télécharger pdf (Page 196)

176

2. Clean the following locations with a cloth moistened with Cleaner F1.

Turn off the ScanSnap before cleaning the following locations.

• Pad ASSY (x 1)

Remove the dirt on the rubber tabs by wiping downward. When cleaning the Pad ASSY,

take care to prevent the cloth from catching on to the metal parts.

• Glass (x 2 located on the ADF and the base unit)

Gently wipe off the dirt and dust from the ADF glass surface.

• White sheets (2 pieces; located on the ADF and opposite side)

White strips along the edge of the ADF glass surface. Gently wipe off dirt and dust from

the white sheets.

• Pick roller (x 1)

Wipe to clean the roller while turning it with your finger, be careful not to scratch the sur-

face. Take particular care in cleaning the pick roller since black debris on the roller

adversely affect the pickup performance.

ATTENTION

It may take long before the cleaner vaporizes if a large quantity is used.

When cleaning the ScanSnap parts, dampen a cloth with modest

quantities of the cleaner. In addition, wipe off the cleaner completely

with a soft lint-free cloth to leave no residue on the surface of the

cleaned parts.

Pad ASSY

Pick roller

Plastic roller (x4)

Eject roller (x2)

Feed roller (x2)

Glass (x2)

(Two places)

White sheet (x2)

(Two places)

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 226 227

Pas de commentaire

Fujitsu S300M Manuel d'utilisateur Page 196