Fujitsu S300M Manuel d'utilisateur télécharger pdf (Page 207)

9.3 Replacing the Pick Roller

ScanSnap S300M Operator's Guide 187

Replacing Consumables

4. Rotate the pick roller bushing (left).

5. Remove the pick roller with its shaft.

Slightly pull up the left part of the pick roller shaft (about 5mm), move it towards the left

side, and then raise it to remove from the ScanSnap.

ATTENTION

If the area around the pick roller is dirty by paper-powder, it may cause a

scanning error. Remove the dirt using a dry cloth moistened with

Cleaner F1.

* Do not use water, mild detergent or air-spray.

Pick roller bushing

Pick roller

Pick roller shaft

Pick roller

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 226 227

Pas de commentaire

Fujitsu S300M Manuel d'utilisateur Page 207