Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur télécharger pdf (Page 10)

3 Flash On-Board Programming

There are two ways to program the on-chip Flash of MB9BF506 series MCU: UART On-

Board Programming and USB On-Board Programming.

3.1 On-Board Programming via UART

 First check the hardware setting as introduced by section 2.3.

 Install the UART programmer: PCWFM3_V01L01. (It can be downloaded on the web)

 Open it, set the parameter as shown in following figure, and select Hex file.

Figure 3-1: UART Programmer Overview

 Click Full Operation.

Figure 3-2: Press Reset Button

 Press reset key in the board, and the programming will start.

Figure 3-3: Start Programming

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur Page 10