Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur télécharger pdf (Page 24)

4) Click “Download and Debug”

Figure 5-7:Click Download and Debug

5) Use following tool bar to debug

Figure 5-8: Debug Tool Bar

The sample codes support both Flash and RAM debug in IAR EWARM Workbench, if Flash

debug is used, the code is programmed into MB9BF506 Flash. If RAM debug is used, the

code only runs in RAM area, and after power off, the code will not be stored, but the RAM

debug will be faster than Flash debug.

 Setting for Flash Debug

1) Check the configuration file path ($PROJ_DIR$\config\mb9bf506.icf) in Linker table.

Figure 5-9: ICF File for Flash Debug

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Pas de commentaire

Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur Page 24