Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur télécharger pdf (Page 30)

5) Use following tool bar to debug

Figure 5-21: Debug Tool Bar

The sample codes support both Flash and RAM debug in Keil uVison 4, if Flash debug is

used, the code is programmed into MB9BF506 Flash. If RAM debug is used, the code only

runs in RAM area, and after power off, the code will not be stored, but the RAM debug will

be faster than Flash debug.

 Setting for Flash Debug

1) Set ROM address in Flash area. (0x00000000-0x00080000)

Figure 5-22: ROM Address Setting for Flash Debug

1 2 ... 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Fujitsu 32-Bit Microcontroller MB9B500 Series Manuel d'utilisateur Page 30