Fujitsu PG-LND101 Manuel d'utilisateur télécharger pdf (Page 68)

5.2 Creating a Team

Perform the following procedures to create a team.

1 Log on with the administrator privileges.

2 Click [Start] → [Settings] → [Control Panel] → [Intel®PROSet

Wired], and start Intel

PROSet.

3 Select a LAN adapter to build in the team, and right click.

4 Click [Add to Team] → [Create New Team...].

The [Teaming wizard] window appears.

5 Select a Teaming type with which you want to create a Team.

• AFT type: "Adapter fault tolerance"

• ALB type: "Adaptive load balancing"

• SFT type: "Switch fault tolerance"

Do not select other types of team.

6 Click [Next].

7 Select LAN adapter to build in the team, and click [Next].

8 Click [Finish].

9 Click [OK] and exit Intel

PROSet.

When the teaming setting is completed, a virtual adapter "Intel(R) Advanced Network

Services Virtual Adapter" appears.

Upper layer protocol is bound to this virtual adapter.

You cannot bind them with the Ethernet controller that makes up a Team.

The IP address is set in this virtual adapter.

10 Restart the system.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Pas de commentaire

Fujitsu PG-LND101 Manuel d'utilisateur Page 68