Fujitsu PG-LND101 Manuel d'utilisateur télécharger pdf (Page 73)

6 VLAN 73

6.2 Creating VLAN

Perform the following procedures to create a VLAN.

1 Log on with administrator privileges.

2 Set the port of the switch connected to the Ethernet controller to

enable send/receive of VLAN tag frames.

3 Click [Start] → [Settings] → [Control Panel] → [Intel®PROSet

Wired], and start Intel

PROSet.

4 Select LAN adapter to set VLAN, and right click.

A VLAN cannot be set to an adapter composing a team.

5 Click [Add VLAN].

6 Set [ID] and [Name], then click [OK].

[ID] must be the same as the set values on the switch. The available range to set is 1 to 4094.

[Name] does not need to be the same as the setting on the switch.

When the confirmation message appears, select [Yes].

7 Repeat Steps 4 through 6 to set respective VLANs.

8 Click [OK] and exit Intel

PROSet.

When configuring a VLAN is completed, a virtual adapter "Intel(R) Advanced Network

Services Virtual Adapter" will appear.

Upper layer protocol is bound to this virtual adapter.

You cannot bind them with the Ethernet controller that makes up a Team.

IP address is set in this virtual adapter.

9 Restart the system.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 79 80

Pas de commentaire

Fujitsu PG-LND101 Manuel d'utilisateur Page 73